2-in-One Drip Irrigation Tubing Hole Punch & Fitting Insertion Tool - for Easier 1/4 Inch Fitting & Emitter Insertion

The hole-punch end of this tool is awesome! The other end that’s supposed to help you install the small fittings into larger tubing is not as nice. It really only works if you have 1/4” tubing already attached to one side of the fitting and the fitting slips out of the tool really easily if you use moderate amounts of pressure because of the angle of the handle.

This tool makes puncturing the main irrigation tubing easier but I did have a little trouble using it to push the fitting into the tubing.

Connecting 1/4 line to 1/2 main line

Not much use untill you drill a 7/32 hole in one of the slots . Then you can use it to hold 1/4 barb fittings while installing them on tubing.

Used for my drip system. Worked as it should, sturdy and easy to use. Point is sharp. If you want holes in your main line to run drip lines....this will work! Would buy again if needed. Buy one and punch some holes!

The punch worked perfectly (thus the 3 stars), however the insertion tool did not work at all. When pushing the barb into tubing, the barb tended to slip off the holder as force was applied. I gave up and just used pliers to do the insertion, which was so much easier.

does not work... not sharp enough to make a hole!

Excellent tool for irrigation repair. Easy to use and very reasonably priced.

This tool makes puncturing the main irrigation tubing easier but I did have a little trouble using it to push the fitting into the tubing.

Best tool Ive found for the job