247 Solder 247-REMALLOY4.5 SMT Removal Alloy 4.5ft

Just works. Low melt solder. Very useful to take out large chips or connector like hdmi or usbz

Ive been using this low melt solder for years. Use a little flux and add a tiny drop of this solder. I usually just use a regular soldering iron and heat it up so this low melt stuff mixes in well. Then the component will just fall off. Takes a little practice and different technique depending on the part you are removing. Sometimes Ive used a heat gun after adding the low melt just to make it easier to heat all the solder points up at the same time. Anyway, I tried buying low melt solder at a lower price from a few different sellers in other countries and the stuff just did not work. This is the real thing and at a good price.

Works very well

Unsoldered surface mount LEDs with ease. This stuff saves the board, the component, and the stress!

It worked as expected

This really helps remove HDMI ports without damaging traces.

Stays fluid longer than regular solder. Works great for sucking the old solder out of a through hole circuit board. I usually can get that job done with out this stuff, but sometimes it is better to just use this stuff and get the job done faster and cleaner without messing up the circuit board.

yes its working very well

Tech for over 30 years, this solder works very well for removing components, stays melted for a decent amount of time and works best if you use flux with it, not only good for smd components but also good to remove bigger components with large ground shields such as joysticks on game controllers. its just as good as chip quik and you get plenty of it should last a while

works great but very expensive