3D Printer Heatsink Kit + Thermal Conductive Adhesive Tape, Cooler Heat Sink Cooling TMC2130 TMC2100 A4988 DRV8825 TMC2208 Stepper Motor Driver Module (22pcs)

Worked great! After installing these on my motherboards vrm, I was able to increase my overclock from 4.3ghz to 4.6ghz stable.

These are good value for money for small aluminum heatsinks. My only complained was one piece was severely crushed as if it had been stepped on and thrown back in the box. Fortunately ten minutes with a pair of pliers restored it to decent condition. Other than that no complaints. Ill likely use them on Raspberry Pi-like devices.

They work nicelly. I only used them for a small project of mine (custom made video capture card) and, coupled with two 25mm fans, it barelly heats up anymore.

The adhesive is useless. I had to spend time cleaning it off so I could put actual thermal tape on these to be able to use them.

Great heat sinks for my duet wifi 2 board. They fit perfect. They will also work for other drivers and other applications. Comes with double side tape on the one side. It holds very strong.

I used these as heatsinks for the VRMs on my old motherboard. First, I super-glued them in pairs, and then stuck them down using the attached adhesive pads. Simple and effective.

I have no idea how well the adhesive transfers heat, but nothing has burnt up. They stayed stuck.

I bought these heatsinks to cool off a hot USB drive as I had one previously burned up and ran very hot. These are perfect size for my use.

Bought for my Ender 3v2s and its keeping the Y motor cool. Would buy again.

fits well and stays on my driver ICs. keeps them cool.