D&D PowerDrive ORB-H-1101 Cub Cadet MTD 754-0461 954-0461 Kevlar Replacement Belt, 1/2 x 78, 4LK Section, Rubber

(0 Reviews)

Price
$26.55

Quantity
(10000 available )

Total Price
Share
100 Ratings
77
14
1
2
6
Reviews
  • Christophe Dooley

    > 3 day

    just like oem

  • Handy-Man G

    > 3 day

    My drive belt broke after 8 years, and this one went on easily and works like a charm. The Kevlar reinforcement should make it stronger than the original belt. Hopefully itll last as long, if not longer.

  • Judi

    Greater than one week

    Did a lot of research for a new belt for my 2007 LT1045 and liked the reviews of this one but was worried about the work required to change it. After the deck was removed I lifted the mower from onto cinder blocks to get underneath it. Next I took the shield of the top of the engine to expose the fly wheel and stuck a large flathead into the teeth and used the solenoid as a brace. With the output shaft now held in place I used a breaker bar to remove the electronic clutch. Installing the new belt was super easy. First feed it back all the way back around the transmission then slide the engine pulley down and put the belt on it. (Second picture) NO NEED TO REMOVE THE ENGINE. If it’s stuck use some pb blaster on it. After the engine pulley is back on all that is left is the three pulleys in the middle( First picture). Put it on the one with the spring and tensioner first then over the last one. And reattach the deck clutch using the flathead again to stop the output shaft from turning. And that is it. Took me about 35 min to change it out.

  • Bryan Cortez

    > 3 day

    It fit

  • Kurt Knispel

    > 3 day

    Used on Cub Cadet Super Lt1554 to replace 754-0461. Belt fit was loose and not at all right. Tried to use a stiffer spring on the tensioner. With tensioner at max still slipped. Absolute garbage. I suspect its a little too long and that most left reviews too soon. I literally couldnt climb a hill. The job to put it on can be extremely difficult if your pulley is stuck etc. Trust me doing it twice is absolutely no fun. Dont buy this belt

  • C-Wayne

    > 3 day

    Great quality. Long life. No complaints whatsoever.

  • Rigger

    > 3 day

    I thought my trans was going bad, it was just the drive belf warn out. Replaced it with this kevlar belt for longevity and all is well.

  • Doug P

    Greater than one week

    Thought the belt coming apart but not so. It is holding up fine after a season of mowing. I have a problem with the pulleys I think.

  • Courtney Eli

    > 3 day

    Great price on an upgraded belt

  • Carolyn Anderson

    > 3 day

    Fit good!

These belts are designed to perform at the identical or higher level than all other major USA Manufacturer�s belts of the same type.

Related products

Shop
( 1815 Reviews )
Top Selling Products