EasyStart MicroAir 368 Soft Start Home Commercial Easy Start (ASY-368-X48), Air Conditioner Soft Start Works with Generator, Start Air Conditioners at Less Power, Home and Commercial Use - Grey

Great product, the run capacitor failed on my compressor, easystart refused to keep trying to start, saving my compressor motor from over heating. Replaced capacitor, all is good. Had to call factory to find out how to clear the error code on my easystart.

During Hurricane Ida, my house was without power for approximately 2 weeks, after which I realized it would have been far more comfortable if I could have run the central A/C using my generator. My two-stage Lennox heat-pump pulls between 2000-3800 watts while running (8-15A), but the startup wattage is about 12000 watts (~48A), which is far more than my

Edit : Just moved from a 2 story house with 2 ac units a 2.5ton 1st floor and a 3ton upstairs and added Kickstarters to both units so my 12kw portable generator could handle the whole house and it did but i knew the generator wouldnt handle the new house with 3.5ton at 119amp inrush edit : so i ordered this a few months back for a new construction home and i waited till i knew what HVAC system was installed so i could order the correct one and i moved in about 2 months ago but between all the smart switches, security system ceiling fans etc etc i finally got to install this and i have to say Im blown away as my 3.5ton unit was pulling 119amps on start (inrush) and i could easily notice the lights dim when the ac kicked on but now Im at 27.5 amps inrush so i know theres no problem my 12k w Duromax dual fuel generator will handle the new home i measured the inrush amps with the meter and compared to the Bluetooth app and was an exact match so overall i am very pleased to the point that i may order 2 more for my old 2 story house Im renting out Edit : so its been a several weeks ago seems to be going great finally got around to installing it in a weather tight box just to give it some extra protection very happy with it

I received the product and quickly noticed how well made it was. Installation was a breeze with only four wires, took me about ten minutes, that included me putting the required ends on. I had one question and sent a text to support. They quickly called me back, when I say quick I mean less than 3 minutes. They walked me through the setup wire by wire to confirm it was installed correctly. My start up Amos was 60 on my 3.5 ton unit. Now my start up amps is 24. Generator now powers my entire house with the ac unit.

Installed on my homes 3.5 Ton 16 seer Trane condensing unit ahead of summer. For the last 2 years I have been trying to identify an electrical issue which occurs when my ac cycles during my home generators weekly test. The air conditioner would run rough and very noisy, sometimes trip itself out on thermal overload. I couldn’t figure It out until I noticed the LRA was 10 amps higher than my generator is rated to produce. A YouTube video from Engineer775 I happened to catch by luck pointed me in the right direction. My results are as follows. I could not believe the RLA in the sticker is 110. I measured 109-112 through my amp clamp. Two years of a mystery why my condenser would make horrible starting noises when running on my home 20kw generator. Preliminary testing shows 24.5 max inrush according to my fluke meter (same meter from initial inrush testing) now that the soft start was installed. My running issues are gone. My lights don’t dim and my condenser runs smooth. I’m impressed to say the least. I have yet to venture into the app and the Bluetooth features but will soon.

Installed this on my whole house Rheem 4 ton unit. Before install the inrush amps measured 113. After 5 learn runs the inrush was down to 29 amps. Anybody who can read the circuit diagram of their ac should be able to install this. The Bluetooth app makes doing the learn runs easy.

These are stupendously expensive but do actually work very well indeed. Has taken a lot of strain off of my solar inverter. The only bad things about it are very short Bluetooth range and the fact that it is on the load side of the contactor so you can only see whats happening when your AC is actually on.

Does exactly what they claim. Line Rush Amps went from 72 down to 23.8

Buy it - Install it - and forget it. Its that easy

We have a 3 ton central AC unit and I decided to switch it to our offgrid system running on a 6K split phase growatt inverter. Everytime when the AC kicked on, the inverter was overloaded and shutoff. After searching around, I decided to buy this unit to test it it out and I am more than happy with the result. Smooth starts of inverter after learning and now the start peak is around 23A which is great. Highly recommended for large AC and offgrid system.