HICTOP Ender 3 Heater Cartridge 24V 40W 1M/39.4Inch for Creality Ender 3 Ender 3 Pro Ender 5 CR-10S Pro 3D Printer Prusa Mendel （Pack of 3）

Replacement for a failed cartridge in my SV03. Been printing now for 24 straight hours and temp has been steady!

Does the job.

I had to replace my heater cartridge for my Prusa mini and it worked fine. Install was quick. Make sure you have a wire ferrule for the endpoint to connect the cartridge to the printer.

Seem to work very well, and cant beat the price. Heats to print temperature in under a minute with a good quality power supply, still using the first one after months on the printer but nice to to have spares handy.

Fail, fail, fail... think you guys can put the same connectors as what is on your printers. Or just leave as bare wire. About to rewire the whole printer using connectors from PCs. At least then they will be easier to work on and interchangable

Fast shipping, worked perfectly.

I have this vs the stock heater cartridge and its not terrible. The wires in the end tend to get frayed if youre not careful so thats kind of a bummer. Also one of the cartridges was a tad too big to fit in the hot end so that kinda sucked too but overall it does its job and it has extra rubber insulation so thats good! Probably would just stick with the OEM ones but Im hoping these last longer.

Great product! As advertised!

Here is an item that works perfectly. Make sure your psu is 24 volt.

works as expected.