Ironslide 2000 Tabletop Cover, 29 by 65-Inch,Silver

I am so disappointed in the package of Bo-Nash I received yesterday. It is like its been stored somewhere forever. When I tried to take off the backing the sticky foam came off in big chunks or stuck to the backing. Its like its old or something. Ive tried every corner with the same results. Not sure if this is the fault of the vendor or the manufacturer. Live & learn I guess; from now on Ill only buy the product when I can see what Im buying.

great product

I love this product, it is easy to install and is wonderful to iron on.

Unusual ironing board cover for an oversized ironing board. Given as gift and loved by recipient.

I just applied mine directly to a 5 X 2 particle board. I ran into all the issues everyone warned about but took extra care - and it worked. - The backing does want to tear into strips, but be careful and after a few inches, you will get it peeling in one piece across the entire short edge. I ironed the piece (on the fabric side) first in order to get out the more serious wrinkles from being folded in the packaging. This heat may have helped loosen the glue a bit so I was able to recover from the tearing of the backing that occurred initially. - The glue and very thin foam backing DOES want to stick to itself AND especially to your fingers. If it sticks to your fingers, it seems to pull the foam away from the fabric and sticks to your fingers instead. Solution: once you have enough of the backing removed, tear off a couple of pieces of that backing and use it between your fingers and the sticky side to hold it down as you peel away more backing. - I peeled away five or six inches all across, pressed it down to my board, held the new stuck edge in place (with a couple of pieces of the torn backing) while I peeled away the next five or six inches. Repeat. Doing just a few inches at a time resulted in great success. I did rush one section and got a minor section where the fabric folded and stick to itself, so be patient. Glue on fingers and scissors comes off easily with a little alcohol. I now have an ironing board wide enough to press full width bolts of fabric. I didnt add any additional batting because I like a firm surface.

My son made a ironing station for me for Christmas. I covered it with the iron slide. Very happy with the results.

Take your time with the install and you will love the product.

If there was a zero I would give this product it. Dont wasted you money on this since all it will do is self adhesive to you and not your ironing board. First I couldnt peel the wax paper off the back without it tearing into a number of strips. In order to remove the little strips I had to remove the adhesive which ended up all over my hands. Trying to get the wax paper off only made the product stick to itself. This created folds and creases which became impossible to pull apart to lay flat on the board. So finally I gave up and Im returning this big sticky, folded and ceases piece of junk.

Goes on easy. Makes ironing much easier because of the easy glide. Great with sewing projects!

This is my third cover and I will buy another when I need to replace it. My first one lasted more then five or six years. I am making a bigger quilters ironing board for current ironing board and am using this as the cover. It is very sticky so make sure you know exactly where you want it to go.