J-B Weld ClearWeld 5 Minute Epoxy, Clear, Syringe, 2 Pack, 50112-2

As described.

Great product! Took a little longer to set up as advertised, but it did the job!

This product takes some getting used to as far as dispensing. If you press a little on either side of the plunger more than thee other just a little you do not get a good mix. Everytime this occurred the mix was sticky for over 8 hours a least. I never got it to dispense where it cured quickly as it was suppose to (5 min), Once it did finally cure it was hard enough to sand, etc., so that was good. Maybe put measurement lines and provide actual amounts so that none is wasted and the 5 min can cure can occur within 5 minutes or redesign the plunger so it does not push more other either side if youre not pushing directly in the middle and do not shift pressure to either side.

This does not work at all! It gets very messing and all over the place!

Two tubes for less than at Wallyworld.

The plastic handle on my oven broke off on one side. This fixed it like a charm

I frequently need to attach metal hardware to wood, and of all the epoxy products Ive tried so far this has been my favorite. The bond is incredibly strong. I havent done any stress/failure tests, but Ive yet to have anything separate. I also appreciate having 5 minutes of set time; there are quicker options out there, but when I use those I find myself stressing out about how much time I need to spend mixing, there is less time to get your parts aligned, and you dont have as much time for adhering multiple work-pieces from a single batch. I find that this product has just the right balance of setting quickly enough that you can get back to work in 30-45 minutes, but you have enough time to make sure everything is in the right position before it gets to gummy. When its about 60°F in my garage, I find that I have about 8 minutes of total work time before the epoxy becomes unworkable. The replaceable cap does a really good job of sealing both reservoirs and preventing curing at the tips (just make sure to back off the syringe slightly before replacing the cap so it isnt pressurized). The packaging comes with a small popsicle stick and theres a concave section in the front cover for mixing; I always use a folded piece of aluminum foil and a lollipop stick for mixing since I do all my projects in a well-stocked garage, but this would be a handy option if you didnt have other supplies available. Some reviewers have commented that they have issues with bubbles, and although I never have this problem, I know why it can occur. If you are mixing the epoxy in a very warm (80°F+) environment / in direct sunlight, it will froth a bit and introduce small bubbles; when possible do the mixing in a cooler environment in the shade. Your mixing technique can also introduce larger bubbles; it should be mixed like drywall mud on a hawk, not like eggs being beaten in a bowl. If you constantly lift your stir stick and push it back down into the epoxy, you will force air into it and create large bubbles that are nearly impossible to get rid of. Instead, constantly keep the tip of your stir stick in contact with your mixing vessel stirring in tight circles; when the epoxy becomes too spread out, use the side of your stir stick to squeegee it back to the middle, then twist the stick to clean off the excess, and resume mixing. 2 or 3 cycles of mix > re-consolidate > clean stir stick should produce perfectly mixed epoxy free of bubbles.

We used this to seal a tank on our camper. Worked great and sealed the leak

I use this for 3d printed projects and it works great with ABS, PLA, and others

I bought this epoxy to repair my broken cement bunny bench. My bench is now back together and looks great. My original intention was to buy a new bench but I could not find one similar. The second option was to try repairing and I am glad I found this product. It works.