MFJ Enterprises Original MFJ-949E 1.8-30 MHz 300 Watt Deluxe Versa Tuner II Antenna Tuner

(1430 Reviews)

Price
$155.99

Quantity
(10000 available )

Total Price
Share
68 Ratings
48
2
6
2
10
Reviews
  • T2000KW

    > 3 day

    This tuner will tune almost anything. The basic model has been around a long time and has proven to be a reliable tuner. Its rather compact for a tuner and should fit into most ham stations. Its fairly easy to tune, and once you tune it for a particular antenna, if you keep a chart nearby, you can readily set it to give you a perfect match on a particular portion of any ham band between 160-10 meters, and if you have the latest model, 6 meters also (I havent personally tried it on 6M). Tuneup on a frequency the first time is easy. First, rotate the three tuning knobs for best reception as a starting point. Then, using low power (just enough to get a full scale meter reading at the low power range of the SWR meter), key the transmitter for a few seconds while making adjustments with the three knobs until you see a low SWR or a perfect match. While its unlikely that youll not get close to a perfect match, if you cant, its time to make adjustments to your antenna, or change its length, whatever it takes. There is a better tuner MFJ makes that has a roller inductor instead of a switched/tapped inductor (it handles 300 watts, too), but this one should match almost any antenna you have without adding the expense of the roller inductor (and it takes a little longer to get the more expensive one tuned the first time for a frequency since you have unlimited steps in between what you would have on this tuner). I like the cross-needle SWR meter that doubles as a power meter. It allows you to quickly see your SWR by looking at where the two needles cross. You cant ask for much more than this for a tuner for a typical HF 100-200 watt ham transceiver, unless you move into the automatic tuners, which are great (I have two of the MFJ auto-tuners, too). But for the price, this is a rugged little tuner. If you are tuning a random wire, make sure you have a good ground or counterpoise (not just a pipe driven into the ground). Ive used this successfully with a 135 foot random wire on all HF bands. It will also let you work the portions of the HF bands on trap verticals/dipoles where the SWR goes high outside the bandwidth of the antenna, making it useful outside the band section(s) where it would normally provide a 50 ohm match for your rig.

  • Neha Pfannerstill

    > 3 day

    works good

  • Randy

    > 3 day

    Works as advertised and surprisingly easy to use. Was able to bring down my SWRs after only a few adjustments...nice. The only item of note is the band selector being a bit stiff and hard to turn. But other than that, this is a great addition to my small shack.

  • 66GTO

    > 3 day

    Like quality and looks but most important it tunes almost all antennas Bravo.

  • Nichole Hermann

    > 3 day

    Love this tunner. It does what it should. I am using it conjuction with a Yeasu 450D radio and a Windom off-center antenna. My tunner tunes all bands that this antenna makes available.

  • The Little Long Fellow

    > 3 day

    This product was intended to match an antenna to a CB radio to give it a perfect standing wave ratio with no reflective power it does exactly what it was intended to do this antenna tuner will probably give a one to one standing wave ratio between any radio and any antenna I’m very pleased with it and I would highly recommend this to other CB radio enthusiast and ham radio operators who desire to have an excellent antenna matcher it’s easy to use and well worth the money

  • Hernan

    > 3 day

    muy desconforme

  • Oklahoma Hypnotist

    > 3 day

    Im satisfied with this tuner because it does what I need to do, so I gave it five stars. As a manual tuner, it is a little awkward to use compared to an automatic tuner, so I dropped a star for ease of use. The box has a power connector in the back to put in 12V to power the light. I dont have easy access to a 12V connector so I have not connected, and the tuner works just fine without any power, since the 12V is only for the lamp.

  • mike

    > 3 day

    Worked it on 11 meters, and it cut my modulation down 75%, and when I got to 20% of my radios power, which is 30 watts, it drove my Swr sky high. Could not get it below 2.5 unless I used 20% of my radios power. Had my neighbor that has the same unit come down with his, and his work fine. Im going to apply for a refund.

  • Everett

    > 3 day

    This unit works well and was just what I needed to tune out my antenna and got my SWRs perfectly flat 1 to 1 and the dummy load allows me to peak out my radio for optimal performance.

More Hams use MFJ-949s than any other antenna tuner in the world! Why? Because the worlds leading antenna tuner has earned a worldwide reputation for being able to match just about anything. Full 1.8-30MHz Operation Custom designed inductor switch, 1000 volt tuning capacitors, Teflon insulation washers and proper L/C ratio gives you arc-free no worries operation with up to 300 Watts 1.8 to 30 MHz. Tunes any Antenna Tunes out SWR on dipoles, verticals, inverted vees, random wires, beams, mobile whips, shortwave receiving antennas.... Nearly anything! Use coax, random wire or balanced lines. Has heavy duty 4:1 balun. Custom Inductor Switch The inductor switch is the most likely component to burn up in any antenna tuner. MFJs inductor switch in the MFJ-949E was custom designed to withstand the extremely high RF voltages and currents that are developed in your tuner. 8 Position Super Antenna Switch Lets you select two coax fed antennas, random wire/balanced line or built-in dummy load through your MFJ-949E or direct to your transceiver. More hams use MFJ-949s than any other antenna tuner in the world! Has MFJs full size 3 inch lighted Cross Needle Meter (not a puny "meter" you cant read). Lets you easily read SWR, true peak forward and average reflected power simultaneously on 300 Watt or 30 Watt ranges. Lamp has on/off switch, requires 12 VDC or 110 VAC with MFJ-1312D, $14.95 QRM-Free PreTune MFJs QRM-Free PreTune lets you pre-tune your MFJ-949E off-the-air into its built-in dummy load! Makes tuning your actual antenna faster and easier. Plus much more! Full size built-in non-inductive 50 Ohm dummy load, scratch-proof Lexan multi-colored front panel, superior cabinet and construction and more!

Related products

Shop
( 1553 Reviews )
Top Selling Products