Micro Swiss .4mm Nozzle for Micro Swiss MK10 All Metal Hotend Upgrade Kit Only

I really like my upgrade to micros swiss hot end but this is the third nozzle that I have had to order for a clogging problem. I use a lot of wood filament so I guess after a lot of use you need to replace them. No problem with the seller or the order.

Nozzles solid, but I got shipped a .2mm nozzle instead of a .6mm I guess Ill keep it and order another.

These work great in my printer, better than the original nozzle.

Zero stars

Quality is as good as a 0.4mm for what I am printing. The difference is it prints twice as fast.

I am using this on a Monoprice Maker Select/Wanhao V2.1. I updgraded to the the Micro Swiss hot end and later picked one of these nozzles up. I prefer the .4mm nozzles compromise between print speed and precision. I only had to head up the old nozzle, unscrew it, and screw this one in. The difficulty factor is painless. I have been using the nozzle for 100 hours of printing so far and have not experience any of the problems the other reviewers ran into. I have not experienced any manufacturer defects with my Micro Swiss products. The main problems Ive run into over the last few years have been related to either the heat break reassembly or bed leveling. Ive had some issues with jamming in a few of my printers, which were related to either needing to adjust the heat break position or correct my bed leveling. Ive included the first benchy I printed with this nozzle which was PETG, a PETG robotic hand, and a PLA dinosaur egg. Ive been satisfied with this nozzle.

Work great, prints well. Takes some time to get the metal hot end dialed in but makes great prints when you do.

Nice nozzles! A direct fit for my Flashforge Creator Pro.

These were way better than what I got with my all metal hot-end kits. The hot-end kit nozzles worked good until worn out. But even then my z-height was always off a small amount. Finally discovered why, the extruded filament comes out of the nozzle with a diameter of about .6 on .4 nozzle. Replaced with this, which has a much more noticeable sharp tip and it extrudes filament right on .4mm. All my issues I had are now gone!

Fantastic nozzle for the Microswiss hotends. Simply screw in and go. Noticed an immediate improvement in print quality.