Opret 5 Pcs FEP Release Film Replacement for ELEGOO Saturn/ANYCUBIC Photon Mono X LCD 3D Printer 185x260mm 0.15mm Thickness 95% Light Transmittance for 8.9 & 9.1 inch Screens

Works great. Easy install.

Print wise, I have had no issues with this film so far and I am 3 prints in. However, in line with some other reviews, I did receive the 2-piece after ordering the 5-piece set. I triple-checked to make sure I did not accidentally purchase the wrong set. Just make sure to check you received the correct order before you open the wrapping or remove your current FEP film as I did.

Received a 2 piece set instead of a 5 piece. Make sure your getting what your buying.

Good funcionality

I have gone through so many of these since I started resin 3d printing. The only thing I do not like about them is how long it takes to switch and undo all the screws but this is no fault to this product. If you resin 3d print you need to put this store in your favorites and be ready to order. Replacing parts in a resin 3d printer is a must

First time changing my FEP sheet out on my Anycubic Photon. Read some other review on this product and figured give it a shot. The packaging is very nice. Seeing as the sheets are incredibly thin and fragile the box they came in was well cushioned. However there was not the best instructions on how to change and tune your FEP. Like tuning a drum you need to have the skin be a certain tightness to have a precise tone. Same goes for the FEP. Aside from looking up a Youtube video on changing the FEP the print quality has been amazing.

Follow the directions. Be sure to use your current vat holes. Don’t make the holes too big

opened this up thinking, this doesnt look like it will fit, and sure enough, its only 130mm wide.

it tore just from leveling the print bed multiple times. i legit thought it was my fault the first two times until it did it again. after the first time leveling it.

This won’t work with the Anycubic Photon Mono stock vat. If however, you replace the vat with an aftermarket one (for example aluminum) then they work great. We replaced the vat as I wanted to be able to use lower-cost FEP replacement than Anycubic’s and it also doesn’t tie me to worrying about their stock.