Original Ender 3 Pro Bed Clips Clamp 7mm for Creality Ender 3 V2 Ender 3S Ender 5 Pro Ender 7 CR-20 PRO CR-10S Pro 3D Printer Heated Bed Glass Bed Platform (Bed Clips)

I bought these because I thought they would be an upgrade t my office clips. For me these clips were way to tight. I have an Ender 3 Pro with a 4mm Creality glass bed, but I noticed when leveling that my glass bed bowed slightly in the middle when these were used. I went back to the office clips and the bed was flat again.

Pros: Heavy Duty Red Wheels; Silicon Spacers; Holding great using only M420 S1 for abl. Cons: Was a bit of a pain to level, but doable. These work great so far. Been on a printer that I just built. Took a while to get the bed level, even with using bed leveling visualizer from octoprint; But now it is set and forget. I probes the bed a few times manually after each print for a few prints and it remained the same. Been printing 8+ hours a day for a week with M420 S1 gcode in place of G29 (load mesh vs creating a mesh every run) with 0 problems. Love it.

While the clips are intended to hold a glass top tight, I found I could barely fit the first clip and the second to tight to get on. Given the glass will grow with heat, I wonder if if it wouldnt even crack the glass itself. Nice, small, good finish but to tight for my application.

Unusable they are to small

Not much to say other than they do exactly what theyre supposwd to do. No more bulky binder clips!

You have to remove the rubber liner from the top of your print bed, or they are a little too tight to use. But they are low profile and clears a lot better than bull clips. These are worth the money.

Received an Ender 3 V2 a few months ago and love the bed clips that came with it. Wanted some for my original Ender 3 with an older Creality glass bed and these are perfect! Snug fit with no movement

Absolutely perfect fit on my Ender 3 Pro with 4 millimeter glass bed. I have the magnetic sheet peeled off from the metal. No other Clips I could find online would fit the bed correctly. Slightly more low profile and definitely better-looking with a tighter grip than just binder clips

1 of the 4 fit loosely so I threw it out, I only use 2 so I have a spare

Clip on and off