[Original]Anycubic I3 Mega 3D Printer Extruder Print Head

Id probably give this 3.5 stars. The only problem is that I needed to swap the heatbreak tube with an all metal one since I run ABS sometimes and it ends up burning the PTFE over time. However this is assembled with so much torque that it is very difficult to get the heat break tube out without stripping the threads (which I have not done). I had to cool the heatsink+heatbreak tube in the freezer and then was able to unscrew it, still with difficulty, using a vice grips while protecting the threads with some rubber wrapped several times around them. They do not have any thermal compound between the heatbreak and the heatsink, so it was just torqued too much. Other than than Im sure its great, as long as there are no plans to take it apart I guess. I am using this with an Anycubic Kossel and the dimensions of this are the same as the one I am replacing, so it is a direct replacement for the Kossel (aside from the electrical parts which I cannot use).

Quick and easy install and works fine

Replacing a worn head couldnt be easier.

Great

My old hot end was getting tired so I replaced it with this. Its fantastic and breaths new life into an old Anycubic Mega

The item is pretty good for its value, it fitted nicely. The downsides to it are that the bowden tube and wires are a bit too short and the wires come with a connector I dont use, so I had to improvise along the way to connect everything to my Kossel Linear Plus. Also, all of the screws are way to tight, which makes replacements a bit hard.

TOss it. get another brand of printer. Anycubic is not a quality machine. They do not stand behind their crap. It will not last a year without having to change tons of parts and they wont help

A great replacement for when my hot end failed on the Anycubic Kossel. I used this hot end to print with both PLA and TPU without any issues.

Worked perfectly in my Antcubic i3 Mega-S

Direct replacement for my AnyCubic i3. I was having problems feeding filament even after a nozzle change, but this did the trick!