Yakamoz 2Pcs 1/4 Shank Top and Bottom Bearing Guide Flush Trim Pattern Router Bit Set Woodworking Cutter Tool with 10 Pcs Top Mounted Replacement Bearings

Did job intended really well, Delivery incredible

clean finish

I was worried because other flush trim bits this long with 1/4 shafts have had bad reviews, and most of the big names dont make them this long - probably because the force applied at that length can really damage a shaft. These bits had no problems. I used them in a Ridgid compact cordless router to trim the bullnoses off thirteen 1 1/2 thick yellow pine stair treads. It was a little slow going but the bit handled it perfectly and is still going strong. Will definitely look for this brand again. Oh - and it was sharp and much less expensive than those big name brands.

On both bits the top bears flew off after on minutes of use.

Now I know why they send extra bearings Bearing fell apart after minimal use Be careful and check bearings often Would not buy again

Good variety of sizes. Works well... Still requires quite a bit of presure to drill hard resin.

As described. Received delivery promptly. Works good, wasnt expecting it to be this good and have different size drill bits. Glad I purchased this instead of the $50 one from the hardware store that doesnt sell the drill bits.

The handle is exactly what I wanted, however when I tried to use the drill bits to drill into soft plastic for miniatures, it was useless. I swapped the drill bit over to something I already owned, and it drilled perfectly. If you buy this, be prepared to buy some drill bits separately.

I use these to drill the barrels on my 40k miniatures, works a treat.

There have worked great