5PCS Creality 3D Printer NTC Thermistor 100K, NTC 3950 100K ohm Thermistor Temp Sensor for Creality Ender 3/Ender 3 Pro/Ender 3 Neo/Voxelab Aquila, XH2.54-2P Connector (1m/39.4inch)

This is the correct replacement part for an Ender 3 printer thermistor. It just wasnt what was causing the problem. That was a fault on the driver board.

Fixed what ailed my Ender 3

Drop in replacement for Ender 3 Pro.

It works for my ender 5 plus with the micro Swiss direct drive

Others said the length was too short. I had no issues with that on my Ender 3. Working great so far, and it’s been a few weeks.

Extremely high quality thermistors at a great price. Worth keeping as spares at this price.

If youre going to use these or anything like them, make extra sure you dont let the insulation get stripped back. Itll happen normally if youre messing with the thermistor a lot and you have it in a drilled hole with the head of a button-head screw holding it in. If the wires coming out of the glass bead touch each other, your control board will die, and itll probably be the microcontroller itself. Beware. If you can, get the threaded stud type thermistor or similar.

Thermistors work well as expected, no product imperfections or irregularities. Shipping time was as expected, thanks.

good, fast shipping

The quality appeared very good. I spliced the wiring rather than thread it all the way to the board. Solder joints and heat shrink. The temp fluctuates +- 4C wildly. I suspect the glass bead is a bit loose fitting. Heat paste may remedy this.