5PCS Creality 3D Printer NTC Thermistor 100K, NTC 3950 100K ohm Thermistor Temp Sensor for Creality Ender 3/Ender 3 Pro/Ender 3 Neo/Voxelab Aquila, XH2.54-2P Connector (1m/39.4inch)

Bought these as a replacement and seem to work well. Looks of good quality manufacturing but with all electronics, only time will tell.

Arrived quickly and came packaged in a padded envelope. However, when testing with an Ohm meter, I got the following resistance for each of the 5 (they are supposed to be 100K): 129K 137K 142K 147K 155K All were tested in the same location with the same temperature. So these are far from accurate. Will have to send them back.

My only complaint is that the wires need to be about 6 inches longer. They worked on my Voxelab Aquila, I just had to be creative with how the wires are positioned in the shroud. My fan wires are now sticking out so the thermistor wires are unimpeded.

Kept having filament clogging problems; this fixed it. Suggest watching a how-to installation video first, really helped.

I used this to replace the thermistor on my Neptune 3 and it seems to be working great. A lot of people say the cables arent long enough. I did not see if it was long enough. I just cut my old thermistor wires and soldered this one on. In my opinion that is far easier than running the cable back to the board. Works as advertised with spares so 5 stars from me.

Glass bead doesnt fit in my Ender 3s heater block. None of the 5 fit.

The quality appeared very good. I spliced the wiring rather than thread it all the way to the board. Solder joints and heat shrink. The temp fluctuates +- 4C wildly. I suspect the glass bead is a bit loose fitting. Heat paste may remedy this.

Easy to install arrived in good time

Product works but the clip is incorrect for CR-10 V3. There is an extra piece of plastic on the side that does not allow the clip to connect. A simple snip of the plastic solved it.

Works as expected