Calculated Industries 7434 AccuMASTER 2-in 1 Magnetic Digital Level and Angle Finder Certified IP54 Dust and Water Resistant,Red Brick Maroon

I tried both the Neoteck and the AccuMaster, both were equally functional and equally accurate after calibration. The Neoteck was more than $15 less, and I was very tempted to keep it. However, I need these devices to measure relative angles when tightening certain bolts with a torque wrench and a swivel socket, and that is where the difference became obvious. I found the magnetic base of the AccuMaster to have a far superior grip to the Neoteck, with the magnets being considerably stronger. The Neoteck performed admirably in all aspects except for its magnetic grip when compared to the AccuMaster: using a long 1/4 extension to torque some difficult to reach valve cover bolts, the AccuMaster stays wherever I place it on the extension; the Neoteck slides down to the valve cover making it impossible to read accurately.

Like it very much. 0.2 degree accuracy. Enough for what I do. Easy to read and use.

It does what it’s supposed to do.

Accurate to the T. I use this for knife making when grinding my bevels and putting edges on knives. Dead accurate little gizmo and I dont know what I would do if I didnt have it. Simple to use and I get consistent, repeatable results.

At times it wont turn on. Have to remove the batteries, check connections, then it works. Other than that, it works great.

Two issues with this. One is the batteries come unseated easily. But when inserted careful not to knock them slightly out of alignment. It doesn’t take much. Two is that my lcd screen broke from a fall height on two feet onto pea gravel. Yes, peagravel broke the screen so apparently it is quite delicate. Also it did this less than two months of me owning the product. The two year manufacturers warranty on calculated industries website says cracked lcd screens are not covered. It did work well the little bit I used it and I like the light up screen and features this angle finder contains, which is why it got 3 stars. I will be ordering a wixey soon just for the durability even if it has less features. Overall disappointed it is so fragile.

I use this in my wood working shop to square up my table saw blade and set the angle as needed. Ive used it for a few other things as well, like on my bandsaw, and to get my drill press table plum and squared to the bit.

I dont know how Ive gone through life without this sensor. I love it.

I have to level with you... I was completely geeked out to get this small tool. Does what it says it will. Easy to use, magnetic and relatively small. I plan on using it to set my blade angles mostly. Comes with a little fabric case/cover.

Works great and I like the easy to read, bright read out. Strong magnet. If I had one wish it would be a second magnetic face at 90 degrees. Happy with this one!