Calculated Industries 7434 AccuMASTER 2-in 1 Magnetic Digital Level and Angle Finder Certified IP54 Dust and Water Resistant,Red Brick Maroon

I tried both the Neoteck and the AccuMaster, both were equally functional and equally accurate after calibration. The Neoteck was more than $15 less, and I was very tempted to keep it. However, I need these devices to measure relative angles when tightening certain bolts with a torque wrench and a swivel socket, and that is where the difference became obvious. I found the magnetic base of the AccuMaster to have a far superior grip to the Neoteck, with the magnets being considerably stronger. The Neoteck performed admirably in all aspects except for its magnetic grip when compared to the AccuMaster: using a long 1/4 extension to torque some difficult to reach valve cover bolts, the AccuMaster stays wherever I place it on the extension; the Neoteck slides down to the valve cover making it impossible to read accurately.

Most accurate one I have bought so far. I would only buy this one again. Other similar ones are not as accurate. I checked these at different degrees with a long level raised up on calibrated shims for eventual use in wheel alignments, and they were dead on.

It digital gauge arrived ready to use. No need to look for batteries, screw driver or a power supply. Came with batteries installed. Works as expected. Easy to read display that shows up clearly in cell phone photos taken for reference and back data in an engineering study being performed.

Must buy once you have a circular saw.

Used this to get the right playfield pitch on my pinball machine. Price was a tad high, but overall I would recommend.

Very, very handy! Great to square up and align blades and whatever else!

Very good

Performs as advertised. Easy to use and good value for your money. Happy with the overall performance. I would recommend to another buyer.

I purchased this to tune up my wood working equipment. It is easy to use and very accurate. I like the fact that your saw doesnt need to be level to use this. You can set this to zero to the surface that you want to calibrate the saw blade to and it will give you the perfect angle of the blade.

good product