5PCS Creality 3D Printer NTC Thermistor 100K, NTC 3950 100K ohm Thermistor Temp Sensor for Creality Ender 3/Ender 3 Pro/Ender 3 Neo/Voxelab Aquila, XH2.54-2P Connector (1m/39.4inch)

Good replacements

Make sure you know what you’re doing. But these are great!

A failed print made it necessary to tear down my print head and clean it. In the process, I broke the thermal sensor. I ordered these to repair it. Unlike several others, I didnt have an issue with the cable length, but thats because I only used the sensor itself. I unsoldered the existing (broken) sensor and soldered one of these in its place. Unfortunately, I now have 5 leftover sensors. But I guess if I ever break another, Im all set.

These thermistors are too big to fit into the hole on the heat block that comes with the Ender 3 v2. Thats an awful thing to discover right at the end of the installation. The thermistor that came out of my Ender 3 v2 is 1.94mm. These are all greater than 1.97mm and none of them fit into the hole on the heat block.

Good direct replacement for creality and ender printers

I needed to replace the thermistor on my hotend and these were exactly what I needed. Easy to install and after a PID auto tune I was back up and printing.

This worked as advertised for my Ender3 V2, no problems

Works

Glass bead doesnt fit in my Ender 3s heater block. None of the 5 fit.

2 out of 5 worked. The right length for an ender 3 pro fit perfectly just 3 didnt work longer then a minute. they fit with cable to spare on an ender 3 pro, customer service was great when i contacted them about half of my order not working then refunded me my money and sent me 3 new ones to replace the ones that where bad at no cost. 5 star customer service all day. would buy again just for the customer service help.