Evergreen CECOMINOD073162 GE • Genteq 1/3 HP 230 Volt Replacement X-13 Furnace Blower Motor

Worked like it was suppose to. Did not include wiring directions so my husband had to go online for help.

No problem s great motor thank you

Works . No issues since installation.def worth getting over paying someone double here local.

It worked perfectly. It was a direct replacement for a genteq x13. I didn’t even have to re-wire anything.

Glad I found this seller. An excellent alternative to ridiculously overpriced OEM blower motor. What wouldve cost me $700+ for the motor alone (not even labor) cost me a little over $260 and the labor was free as a DIY. Excellent fit and finish. Motor took right off and ran as quiet and good as the original. Cut out the middle men and go with Genteq, you cant go wrong!

Excellent drop in replacement blower motor for the air handler in our Heat Pump, priced a fraction of what the original manufacturer quoted for a replacement, did not require programming. My inquiries to Technical Support both by telephone & Email were quick & professionally done. I will be recommending your products to others that require this type unit. Excellent in all regards,

Great replacement for my carrier system, but not the best. Quality seems lacking. Where my original and more expensive motor had the shaft perfectly placed in the middle of the hole, this shaft was literally touching a little on one edge of the hole. I was even worried before installed, but everything seemed to work fine. This motor is louder, period. It is ok, but it is louder no doubt. I believe this is mainly due to the fact this motor spins 25x times more per minute vs the original. Also, quality is lacking, so a bit lauder. I also noticed the extra airflow due to the extra rpm, but this hasnt affected the way my AC functions. I have mixed feeling about this, but I guess Ill get used to it. And this is why I wanted you to read, nobody seems to mention these basic and super important points in my opinion. Would I recommend it? Sure! I rather have this vs the original, considering the original costs twice or more. I have never done this before, and I did it successfully, no need to use the included electrical harness. Everything was connected the same vs older motor. So dont be afraid if you never done it, theres always a first time for everything. Edit: Motor still working fine after a couple of weeks. I forgot to mention this motor will stop immediately after your compressor outside stops. Usually your blower motor will run for about a minute, but this one does stop immediately, which I dont like at all. I have a smart ac thermostat, so what I do is to start the blower motor fan before I shut the AC down. That way the blower motor keeps working without stopping. Theres always some residual cold left behind in your coils, so for efficiency is good to run the blower motor, more o less as long the air still blowing cold. Final Edit: Definitely lauder than the original. When youre running the heat it gets even lauder. Blows more air I guess. Made one of my vents vibrate, so I had to do a little fix there. Heating performance is fine but I dont like the noise. Ac cooling performance is definitely worse. Because this motor runs at a higher rpm, it throws things out of place. Humidity levels in the house are quite higher by about 8 to 15 % more. I will still keep it because of the money I originally saved and mostly because I dont feel like doing the work again, but if you are about to buy this, do not! Get the real deal, pay a couple hundred more if you can and you will be way happier.

Worked perfect just like OEM

HVAC tech came and diagnosed problem as the EMC in the blower motor. Quoted $300+ just for the EMC, & $600+ to replace the motor, and then $250 for installation. Ordered Evergreen blower motor for $210, my husband installed it himself, and within 4 minutes, our heat was working just fine. Would definitely order again! Saved us A LOT of money

Nice malti use moter.