Polycarbonate Clear Plastic Sheet 12 X 18 X 0.0625 (1/16) Exact, EasyRuler Film, Shatter Resistant, Easier to Cut, Bend, Mold Than Plexiglass. VEX Robot, Hobby, DIY, Industrial. Glass Replacement

I purchased it because I couldnt find the size that I needed at Lowes. The piece I ordered was enough for 1 pane and I needed 2 panes. This piece was thin and had flex to it. I went to Home Depot and found a thicker Lexan piece for the same price and it was much better. Next time its Home Depot for me.

I have a beautiful print that feel off the wall and the glass cracked. I didnt want to replace with another glass piece so I searched for a single sheet of plexi to shield my print. I knew I made the right choice with this piece. It arrived the next day and packed safe from damage. Both sides were covered in a protective film. The plastic sheet was super clear, thick and with no tint.

I used this piece to form a border for my iRobot sweeper near my patio doors. Easy to cut and easy to glue to the edge of my patio door rails. This allowed me to be able to open and close the doors without interference AND prevent my iRobot from getting stuck in those same rails. I was able to cut several 3 borders.

Good

Cut very easy….. scored a couple times with a razor blade and then snapped off piece. I used it as a divider for a reptile enclosure.

In reviews of this product quite a number of persons commented that this plastic sheet was easy to cut -- My reply: What were they using to cut it--a band saw? I tried a new #11 X-Acto blade; then a utility knife with a heavy-duty blade; then a heavy-bladed paring knife honed to a razors edge--I can cut through chicken bones with this knife with hardly any effort. I finally had to resort to heavy kitchen shears that go through plastic blister pack material like butter -- I still wound up with an uneven line that had to be sanded straight. Perhaps other reviewers were mentally comparing this to sheet metal or quarter-inch Lexan? Unless you have the strength of 2 men or access to industrial grade cutting tools, do not buy this thinking it can be cut easily using standard hobbyist tools. If you need this product regardless of relative cutability, please consider also purchasing a thin kerf saw to go with it. It is a good quality product / Most persons will not find it easy to cut -- Honest!

If you intend to use this as a flat surface, it should work ok. I tried to glue and clamp it on a Chevy instrument panel cluster which is not flat and it kept snapping off even after clamping for 48 hours. The old broken cover I took off and was trying to replace with this acrylic piece was about 1/2 the thickness of this 1/16 thick piece, so just wished I could find a 1/32 thick product. Or like my headline states, I wish it was more pliable. I finally used a slow setting epoxy which did run on the inside of the acrylic piece, but when I left it clamped for 4 days, just to make sure the epoxy had cured, it did hold this acrylic piece in a curved positon. Not a perfect job, since I had epoxy that ran and several scratch marks from trying to clamp several times. Basically, it just was not thin enough or pliable enough for my project. It will probably work fine for any project that requires a flat acrylic piece. Not permanently curved.

It was exactly what I needed. Cuts nice with razor knife. Has protected cover on both sides.

Just received this sheet and, within 10mins, its cut to size and on my tank! Looks great and was very easy to cut. I used a cheap box-cutter. Scored it several times and snapped the cut. Works great. Serves its purpose well!

perfect to protect you entire face. Easy to adjust. Doesnt fog up. Great for working with chemicals. I think Ill buy another