Freud 40-114: 1-5/8 (Dia.) Chamfer Bit
-
Dave Tela
> 3 dayIt is nice when good tools are available and never need return. I purchased it for a specific project and the bit cut a very smooth bevel.
-
Richard D. Webb
> 3 dayuse this to make octagonal shapes
-
Frank T. Stover
> 3 daywe use it to get a nice 45 on cabinet panels. it works nuch beter than any of the saws we have used. the corners are perfect.
-
JG
> 3 dayHigh quality and durable!
-
Dr. Nora Oberbrunner III
> 3 dayGood little 45 chamfer bit. Needed a 1/2 to go in my Bosch 2-1/3HP and this did the trick. No complaints, it works as youd expect.
-
James Harris
> 3 daySo far it has been doing very well. I have only used it on about twenty doors and drawer fronts for an edge. Freud has always been one of my choices. I am disappointed though that some of their bits are now being made in China. Very disappointing for me. I truly worry about thier commitment to quality.
-
James A Holland
> 3 dayIve used this once and its better than most of the router bits Ive got. I would definitely but it again.
-
Ramesh
> 3 dayVery clean cut!!
-
J. S. Ragman
> 3 dayI only work with hardwoods and this blades cuts over and over a very clean cut
-
Squirt Washburn
> 3 dayPros: The bit is well made and cuts well. Cons: The guide bearing is very thin and when you put pressure on it while cutting you can leave a mark on soft woods like pine. I solved the con issue by making the chamber in two cuts and not putting a lot of pushing the router against the work piece.